Swing into Fall

Hello Friends 

It is time to show off our new RELEASE!  It is our Fall Designs for 2023.  Perfect for those Thanksgiving cards and fall birthdays. The new dies are in the online store.  There are 15 designs and they are currently 30% off! 

I am sharing a card using the Fall Branch w/Swing and Autumn Friends

Design Steps

1.  For the base use a cream A2 size. Using largest Wide Pierced Retangle Frame die cut out 2 in teal,  cut a piece of leave rust DP 4 1/8 x 5 3/8 and use a piece of cream cut to fit inside of the rectangle frame 3 1/4 x 4 1/2.  Use some teal ink and blend it on the cream colored rectangle

2.  Glue the leave DP to the card base.  Glue the two teal frames together and then add dimension tape to the back of the frame.  

3. Glue the inked paper to the center of the card and then pop the frame over the top

4.  Using the Fall Branch w/Swing and the Autumn Friends die cut out the following colors of card stock: rust, cream, teal, yellow, brown, and dark brown

5.  Place some dimension squares to the back of the branch and swing.

6.  Pop the branch and swing to the card as shown.  Add dimension dots to the back of the little fox and then pop him onto the swing.  Add the leaves to the tree branch and a few to the bottom of the frame.  Stamp your sentiment then layer onto yellow.  Glue the sentiment to the frame as shown below and your card is complete

We have more inspiration on our YouTube Channel check it out HERE

Thanks so much for stopping by!  And I will see you next Thursday.

Blessings and Take Care